Determining Dynamic Properties of Elastomer-Dampers by Means of Impact Testing

Experimental Mechanics, vol. 62, pp. 823–836

Abstract

Abstract Background Damping elements made of elastomer materials are used in almost every mechanical system to prevent damage to components caused by impact-like excitations and the resulting high-frequency, large-amplitude oscillations. The dynamics of these operating conditions exceed the performance limits of conventional experimental testing methods, impeding validated predictions of the damper’s transmission behaviour. Objective A method is proposed to directly investigate the influence of impacts on the transmission behaviour of elastomeric dampers by impact testing. Methods Torsional-loaded elastomer dampers were experimentally investigated using a drop tower. During the experiment, a mass is brought into impact contact with a lever arm connected to the tested coupling. Measurements on resulting torsional oscillations and a comparison of the measurement results with a simple analytical model of the system allow for determining the coupling parameters stiffness and damping ratio. Results The characteristic parameters stiffness and damping ratio of the elastomer damper were mapped as a function of excitation-amplitude and frequency. A comparison of drop-tower test results with servo-hydraulic measurements validated the determined parameters. Conclusions Determining the transmission behaviour of elastomeric dampers from highly dynamic and impact-induced oscillation states proved to be a good approach to supplement established testing methods.

Authors 4

1. Tobias Rapp corresponding Aachen Institute for Machine Elements and Systems Engineering

   RWTH Aachen University

   Affiliation as printed

   Institute for Machine Elements and Systems Engineering (MSE), RWTH Aachen University, Eilfschornsteinstraße 18, 52074, Aachen, Germany

2. Georg Jacobs Aachen Institute for Machine Elements and Systems Engineering

   RWTH Aachen University

   Affiliation as printed

   Institute for Machine Elements and Systems Engineering (MSE), RWTH Aachen University, Eilfschornsteinstraße 18, 52074, Aachen, Germany

3. Joerg Berroth Aachen Institute for Machine Elements and Systems Engineering

   RWTH Aachen University

   Affiliation as printed

   Institute for Machine Elements and Systems Engineering (MSE), RWTH Aachen University, Eilfschornsteinstraße 18, 52074, Aachen, Germany

4. J. Guenther Aachen Institute for Machine Elements and Systems Engineering

   RWTH Aachen University

   Affiliation as printed

   Institute for Machine Elements and Systems Engineering (MSE), RWTH Aachen University, Eilfschornsteinstraße 18, 52074, Aachen, Germany