A Unified Approach for the Quantitative Comparison of Strain Gauge and Blade Tip-Timing Measurement Results for Blade Vibration in Turbomachinery

Journal of Engineering for Gas Turbines and Power, vol. 148

Abstract

Abstract Accurate measurement of blade vibrations in turbomachinery is crucial for precise service life assessment. The most commonly employed techniques are strain gauge (SG) and blade tip-timing (BTT). While BTT has gained prominence over the past decades due to its nonintrusive nature, it is limited by undersampled data, leading to uncertainties when applied to impellers with unknown vibration frequencies. To compensate for this limitation, BTT is often accompanied by SG for vibration frequency identification. However, a quantitative comparison between these methods is challenging due to differences in the measured quantities, sampling resolution, and evaluation procedures. This paper addresses the discrepancies between SG and BTT measurements and proposes a unified methodology for their quantitative correlation. A numerical modal analysis is conducted to derive mode-dependent conversion factors (CF) between the SG measurements and the tangential deflections captured by BTT. To ensure accurate time-domain comparisons between the measurement techniques, the methodology incorporates the synchronization of their evaluation windows and validates them by comparing vibration properties such as amplitude, resonance frequency, and damping. Additionally, the uncertainty of the actual SG position and orientation as well as the correction of the axial BTT measurement plane are meticulously analyzed to refine the CF. The proposed methodology is validated using experimental data from a radial impeller acquired from an exhaust turbocharger test bench. These results not only improve the reliability and precision of vibration analysis in turbomachinery but also offer a comprehensive framework for future applications in blade health monitoring.

Authors 3

1. Markus Schafferus Aachen Institute of Power Plant Technology

   RWTH Aachen University

   Affiliation as printed

   Institute of Power Plant Technology, Steam and Gas Turbines , Aachen, NRW 52074, Germany

   Institute of Power Plant Technology, Steam and Gas Turbines, Aachen, Germany

2. Marios Sasakaros Aachen Institute of Power Plant Technology

   RWTH Aachen University

   Affiliation as printed

   Institute of Power Plant Technology, Steam and Gas Turbines , Aachen, NRW 52074, Germany

   Institute of Power Plant Technology, Steam and Gas Turbines, Aachen, Germany

3. Manfred Wirsum Aachen Institute of Power Plant Technology

   RWTH Aachen University

   Affiliation as printed

   Institute of Power Plant Technology, Steam and Gas Turbines , Aachen, NRW 52074, Germany

   Institute of Power Plant Technology, Steam and Gas Turbines, Aachen, Germany