VHCF behavior and defect tolerance of modified bainitic 100Cr6 with a high retained austenite content

International Journal of Fatigue, vol. 185, pp. 108378

Abstract

Since the fatigue life of high strength steels, e.g., roller bearing steel 100Cr6, depends on microstructural defects, an improvement of their defect tolerance can enhance the performance of components. To improve the defect tolerance, the retained austenite content can be increased. Thus, in this work the high cycle and very high cycle fatigue behavior of two modified laboratory variants of 100Cr6, which have an increased content (1.5 wt%) of Al and Si, respectively, were analyzed since these alloying elements lead to higher fractions of austenite. Moreover, an industrially available variant with 0.6 wt% Si was analyzed as a reference. All steels were investigated in the bainitic condition and had austenite contents of about 20 vol-%. However, the distribution and chemical composition of the austenite differed. The presented results demonstrate that the effect of retained austenite on defect tolerance is caused by i) the increased ductility and ii) the local deformation-induced phase transformation. To strengthen the effects of the austenitic phase, a finer distribution as well as a lower austenite stability are useful. Consequently, to evaluate the effect of retained austenite on the fatigue behavior the content, the distribution and the chemical composition of the austenitic phase must be considered.

Authors 4

1. Pascal Ostermayer

   Rheinland-Pfälzische Technische Universität Kaiserslautern-Landau

   Affiliation as printed

   Institute of Materials Science and Engineering (WKK), RPTU Kaiserslautern-Landau, Germany

2. Bastian Blinn corresponding

   Rheinland-Pfälzische Technische Universität Kaiserslautern-Landau

   Affiliation as printed

   Institute of Materials Science and Engineering (WKK), RPTU Kaiserslautern-Landau, Germany

3. Ulrich Krupp Aachen Steel Institute

   RWTH Aachen University

   Affiliation as printed

   Steel Institute (IEHK), RWTH Achen University, Germany

4. Tilmann Beck

   Rheinland-Pfälzische Technische Universität Kaiserslautern-Landau

   Affiliation as printed

   Institute of Materials Science and Engineering (WKK), RPTU Kaiserslautern-Landau, Germany