Deep Regularized Waveform Learning for Beam Prediction With Limited Samples in Non-Cooperative mmWave Systems

IEEE Transactions on Vehicular Technology, vol. 72, pp. 9614–9619

Abstract

Millimeter wave (mmWave) systems need beam management to establish and maintain reliable links. This complex and time-consuming process seriously affects communication efficiency. Benefiting from data-driven technology in deep learning, the beam can be predicted from the waveform without coordination between transceivers. By passively listening enough waveforms that are transmitted from the base station (BS) to other receivers, the BS can predict which beam is suitable for transmitting in the downlink. However, training such a waveform learning neural network usually requires a large number of labeled training samples. This is a huge challenge, because it is difficult for the receiver to get the precise signal parameters from the transmitter in advance in the non-cooperative mmWave system. As a result, the limited samples may cause overfitting and seriously restrict the performance. Although the data augmentation technology can improve the performance under limited samples, existing data augmentation methods are mostly based on strong prior knowledge which cannot further exploit the potential characteristics of data in the real environment. This paper proposes a mixed regularization training method for training the beam prediction neural network under limited training samples. Specifically, data augmentation is implemented in the data pre-processing procedure with prior knowledge and then the signal splicing strategy is proposed in the training procedure. In order to mine the time correlation characteristics of signals, the cyclic time shift (CTS) based data augmentation method is proposed in the data augmentation step. The simulation results show that our proposed deep regularized waveform learning method needs less training samples under the same performance. Moreover, the proposed method can achieve best performance compared with existing data augmentation methods.

Authors 6

1. Hao Huang

   Nanjing University of Posts and Telecommunications

   Affiliation as printed

   College of Telecommunications and Information Engineering, Nanjing University of Posts and Telecommunications, Nanjing, China

2. Guan Gui

   Nanjing University of Posts and Telecommunications

   Affiliation as printed

   College of Telecommunications and Information Engineering, Nanjing University of Posts and Telecommunications, Nanjing, China

3. Haris Gacanin Aachen Faculty of Electrical Engineering and Information Technology

   RWTH Aachen University

   Affiliation as printed

   Faculty of Electrical Engineering and Information Technology, RWTH Aachen University, Aachen, Germany

4. Chau Yuen

   Singapore University of Technology and Design

   Affiliation as printed

   Engineering Product Development (EPD) Pillar, Singapore University of Technology and Design, Singapore

5. Hikmet Sari

   Nanjing University of Posts and Telecommunications

   Affiliation as printed

   College of Telecommunications and Information Engineering, Nanjing University of Posts and Telecommunications, Nanjing, China

6. Fumiyuki Adachi

   Tohoku University

   Affiliation as printed

   International Research Institute of Disaster Science (IRIDeS), Tohoku University, Sendai, Japan