Development of an intra-carbonate detachment during thrusting: The variable influence of pressure solution on deformation style, Khao Khwang Fold and Thrust Belt, Thailand

Geosphere, vol. 17, pp. 602–625

Abstract

Abstract Classic detachment zones in fold and thrust belts are generally defined by a weak lithology (typically salt or shale), often accompanied by high over-pressures. This study describes an atypical detachment that occurs entirely within a relatively strong Permian carbonate lithology, deformed during the Triassic Indosinian orogeny in Thailand under late diagenetic-anchimetamorphic conditions. The key differences between stratigraphic members that led to development of a detachment zone are bedding spacing and clay content. The lower, older, unit is the Khao Yai Member (KYM), which is a dark-gray to black, well-bedded, clay-rich limestone. The upper unit, the Na Phra Lan Member (NPM), comprises more massive, medium- to light-gray, commonly recrystallized limestones and marble. The KYM displays much tighter to even isoclinal, shorter-wavelength folds than the NPM. Pressure solution played a dominant role throughout the structural development—first forming early diagenetic bedding; later tectonic pressure solution preferentially followed this bedding instead of forming axial planar cleavage. The detachment zone between the two members is transitional over tens of meters. Moving up-section, tight to isoclinal folds with steeply inclined axial surfaces are replaced by folds with low-angle axial planes, thrusts, and thrust wedging, bed-parallel shearing, and by pressure solution along bedding-parallel seams (that reduce fold amplitude). In outcrops 100–300 m long, reduction of line-length shortening on folds from >50% to <10% shortening upwards indicates that deformation in the NPM is being accommodated differently from the KYM, probably predominantly by shortening on longer wavelength and/or spacing folds and thrusts, given the low amount of strain observed within the NPM, which excludes widespread layer-parallel thickening.

Authors 4

1. C.K. Morley

   PTT Public Company Limited (Thailand) · PTT Exploration and Production Public Company Limited (Thailand)

   Affiliation as printed

   PTT Exploration and Production, Enco, Soi 11, Vibhavadi Rangsit Road, Chatuchak, Bangkok, 10900, Thailand

2. Sukonmeth Jitmahantakul

   Chulalongkorn University

   Affiliation as printed

   Basin Analysis and Structural Evolution (BASE) Research Unit, Department of Geology, Faculty of Science, Chulalongkorn University, Bangkok, 10330, Thailand

3. Christoph von Hagke Aachen Institute of Geology and Palaeontology

   University of Salzburg · RWTH Aachen University

   Affiliation as printed

   Department of Geography and Geology, Salzburg University, Hellbrunnerstraße 34, 5020 Salzburg, Austria

   Institute of Geology & Palaeontology, RWTH Aachen University, Miner Building, Wullnerstrasse, 2, 52056, Aachen, Germany

4. John K. Warren

   Chulalongkorn University

   Affiliation as printed

   Department of Geology, Faculty of Science, Chulalongkorn University, Phayathai Road, Bangkok, 10330, Thailand